mohamed_eng 0 Posted December 25, 2011 In the CCTV system there 7 sequences already programmed For example I called sequence no. (2) on a specific monitor. It showed 6 consequitive cameras with 3 seconds time interals When I called the same sequence no. (2) on another monitor. It showed the same 6 cameras but with 6 seconds time intervals between them What I need to know is how to change the time intervals for any of the monitors and how to program a new sequence for any monitor and choose this sequence number P.S.: The model of the keypad I'm using is KTD-405 Share this post Link to post Share on other sites
Soundy 1 Posted December 26, 2011 Found the manual here: http://www.fitch.ca/word/Kalatel/ktd_405_man.pdf "5.2.8 PROGRAMMING A DVMRe/MULTIPLEXER CAMERA SEQUENCE" starts on page 40. Share this post Link to post Share on other sites
mohamed_eng 0 Posted December 26, 2011 Thank you for that Actually I already got the manual and knew how to program the sequence I need, but the question is how to assign a specific number to the sequence I'm programming meaning how to determine that the sequence I'm recording will be sequence number 3 or 4 or any other number so I can call it after the programming Thank you again for trying to help Share this post Link to post Share on other sites
tomcctv 190 Posted December 26, 2011 Thank you for that Actually I already got the manual and knew how to program the sequence I need, but the question is how to assign a specific number to the sequence I'm programming meaning how to determine that the sequence I'm recording will be sequence number 3 or 4 or any other number so I can call it after the programming Thank you again for trying to help how to determine that the sequence I'm recording will be sequence number you are not recording the sequence ..... this is just a preferance on what you want to see on your monitors Share this post Link to post Share on other sites
mohamed_eng 0 Posted December 26, 2011 you are not recording the sequence ..... this is just a preferance on what you want to see on your monitors hmmmmm you mean that this will only show the sequence on the monitor ?? but what if I wanna save the sequence so I can call it anytime after that I need to show a specific camera on the monitor and be able to call the sequence whenever I need it The button "SEQ" on the keypad calls the stored sequences from 1 --> 7 but I don't know how to store any new sequence under a specific number Share this post Link to post Share on other sites
