Bob La Londe 0 Posted January 12, 2012 I recently upgraded my DS2P 1st generation to a more current software revision. This is the demo unit I use in my office to show customers. Pelco-P quit working. I can control cameras using Pelco-C, but as you know that protocol is not fully implemented on the DS2 DVRs and you can not use all of the functions of a Pelco PTZ camera with C prototcal enabled. The only reason I updated the software is because the first generation DS2P did not have any password protection. Now that I am frequently using my laptop or even my cell phone for demos, and I opened the DVR up to the Internet from more than a very narrow range of incoming IP addresses I decided I needed the password protection at a bare minimum. None of the telelmetry settings for P were changed, and the unit has been restarted several times. Any suggestions? DM did not respond to emails regarding this issue. Share this post Link to post Share on other sites
Bob La Londe 0 Posted January 12, 2012 I recently upgraded my DS2P 1st generation to a more current software revision. This is the demo unit I use in my office to show customers. Pelco-P quit working. I can control cameras using Pelco-C, but as you know that protocol is not fully implemented on the DS2 DVRs and you can not use all of the functions of a Pelco PTZ camera with C prototcal enabled. The only reason I updated the software is because the first generation DS2P did not have any password protection. Now that I am frequently using my laptop or even my cell phone for demos, and I opened the DVR up to the Internet from more than a very narrow range of incoming IP addresses I decided I needed the password protection at a bare minimum. None of the telelmetry settings for P were changed, and the unit has been restarted several times. Any suggestions? DM did not respond to emails regarding this issue. Apparently something changed in the variables. A factory default seemed to fix the problem. (Not a restart). Share this post Link to post Share on other sites
