crow 0 Posted January 25, 2012 hi im new to cctv yesterday (but did lots of reading last night about entering protocol settings and board rate and adress e.c.t a friend of mine has an apollo lite 8 and a keyboard joypad controller this on below http://cnfulicom.en.made-in-china.com/product/moqEbQRUJKVM/China-PTZ-Keyboard-Controller-FC-KB802B-.html there are 4 cameras 2 are ptz ones 001 and 002 all 4 cameras show the display outside perfect but 1 of the ptz cameras 002 doesnt move with the keyboard controller and on the display monitor it has lots of writing on the screen like the protocol adress and board rate e.c.t the ptz camera has displayed this since they had a power cut and to make things worse the wires fron the keyboard controller got riped out i read about the RS485 and got the info that it uses 2 wires to the RS485 + and - on the keyboard controller there were 3 wires that had the coating stripped off yellow blue and white i got the 001 camera to work by conecting the blue and yellow and left the white wire out (not sure if it has to do with the problem with the 002 camera not moving) i have read about inputing the protocol settings and adress and board rate e.c.t and managed to get 001 camera working ok but not 002 any help please Share this post Link to post Share on other sites
sonyfcb 0 Posted February 4, 2013 hiim new to cctv yesterday (but did lots of reading last night about entering protocol settings and board rate and adress e.c.t a friend of mine has an apollo lite 8 and a keyboard joypad controller this on below http://cnfulicom.en.made-in-china.com/product/moqEbQRUJKVM/China-PTZ-Keyboard-Controller-FC-KB802B-.html there are 4 cameras 2 are ptz ones 001 and 002 all 4 cameras show the display outside perfect but 1 of the ptz cameras 002 doesnt move with the keyboard controller and on the display monitor it has lots of writing on the screen like the protocol adress and board rate e.c.t the ptz camera has displayed this since they had a power cut and to make things worse the wires fron the keyboard controller got riped out i read about the RS485 and got the info that it uses 2 wires to the RS485 + and - on the keyboard controller there were 3 wires that had the coating stripped off yellow blue and white i got the 001 camera to work by conecting the blue and yellow and left the white wire out (not sure if it has to do with the problem with the 002 camera not moving) i have read about inputing the protocol settings and adress and board rate e.c.t and managed to get 001 camera working ok but not 002 any help please HI you shall Push the button : CAM+ 2 +Enter and then you can control the 002 speed dome . If any question , contact me by email : Vidocanada@gmail.com Philip Skype : Philip.Vido Share this post Link to post Share on other sites
tomcctv 190 Posted February 4, 2013 If any question , contact me by email : all posts you are posting in are 1 or 2 years old....... any reason why you want to take people away from forum ??? Share this post Link to post Share on other sites