jtetterton 0 Posted March 2, 2012 I'm lost here, probably missing something tiny, but I just can't figure this out. I *think* I've set my cameras to record 24/7 and allow me to search for just motion events. Please see screen shots: For the "region" setting under each channel, i've highlighted the entire FOV with the light blue to make it "active". Whenever I search for motion recordings, it just tells me "No record". Any help is appreciated! Thanks, Jason Share this post Link to post Share on other sites
SEANHAWG 1 Posted March 2, 2012 Hi Jason, It indeed looks like you have channel 1 setup properly for MD recording. I am not sure about the other channels though. What happens when you just search for channel 1? What happpens when you search at the console? Are you computer time and your DVR time mathched up? Just make sure that one is not one hour behind the other, a few minutes off is no big deal. Share this post Link to post Share on other sites
jtetterton 0 Posted March 2, 2012 Hey Sean, Just searching channel one gives me the no record message. I'll have to take a monitor downstairs to try searching from the console. Will report back after work Jason Share this post Link to post Share on other sites
jtetterton 0 Posted March 3, 2012 So I hooked a TV up directly to the DVR and I think I've found the problem. I noticed that the motion indicator was constantly on for all channels. Apparently the sensitivity was too high and the motion was constantly being triggered. I bumped it down to 4 and the motion indicators went off. Maybe this will resolve it, i'll try searching again after capturing some more footage. Share this post Link to post Share on other sites
SEANHAWG 1 Posted March 3, 2012 Hi Jason, That happeed to me one time and I dont know why. Actually, what I have found is that a good reboot will stop the issue. these are like computers and act like computers sometimes, meaning that a reboot will take care of funky issues. If you can, you may completely re-format your hard drive and start clean over. First, you may just try a reboot to see if that helps. Share this post Link to post Share on other sites
SEANHAWG 1 Posted March 3, 2012 Also Jason, You are recording channels 1, 3 and 4 for channel 1 motion Share this post Link to post Share on other sites
jtetterton 0 Posted March 3, 2012 Yep, that was the plan, to record all angles in the front when any are triggered. 1 3 and 4 all share a partial field of view in the front. Share this post Link to post Share on other sites
