pekingduck08 0 Posted March 17, 2012 Hello everyone! I am planning to design this system and I need someone else's comments regarding possible problems that could arise upon its installation. I would highly appreciate any comments and recommendations.. Thanks! Share this post Link to post Share on other sites
thewireguys 3 Posted March 17, 2012 What equipment are you planing on using for this project? Share this post Link to post Share on other sites
Soundy 1 Posted March 17, 2012 Your network topology doesn't entirely make sense... for example, why are you chaining through two PoE adapters between the main switch and camera 1B at the far bottom-right? PoE adapters are not ethernet extenders. Share this post Link to post Share on other sites
ssmith10pn 0 Posted March 17, 2012 Yea I'm lost on the network topology. Share this post Link to post Share on other sites
tomcctv 190 Posted March 17, 2012 i also think you have over complicated things. and there are also cable lenths to take into account. also you have PTZs going to POE switch with other cameras you may find you dont have enough power. DVR/NVR = hybrid ???? same as thewireguys asks what equipment are you using MP each camera ?? power each camera and your wireless link for you anpr cameras how far ??? Share this post Link to post Share on other sites
Soundy 1 Posted March 17, 2012 He has separate power supplies (PS) for the PTZs... it's hard to see, but the blue lines are network and the black lines that all tie together are power. Share this post Link to post Share on other sites
pekingduck08 0 Posted March 18, 2012 I added the distance of each cameras from the switches.. Cameras 1B-25B : Bullet IP cameras Camera 1D : Dome IP camera Camera 1A-3A : Arctic IP cameras Camera 1P-2P : IP PTZ cameras Camera LPR1-LPR3 : LPR cameras Im using GeoVision Cameras, Hot Swap DVR, and GV-PA191 PoE Adapter.. I don't know yet what brand for the other PoE Switches.. Share this post Link to post Share on other sites
pekingduck08 0 Posted March 18, 2012 I wanted the power of all cameras and switches to be drawn only from the monitoring room.. the farthest distance is about 300 meters from the monitoring room.. im thinking if I could use NVT products for this.. What will you recommend? Share this post Link to post Share on other sites
