wildwind 0 Posted April 18, 2012 Hi all, I have a Pico UCC4 Conexant 878A card running the DICO-800 software. I have a 600TVL CCD HAD camera but it only recognized 320x240 resolution. It would not detect the higher resolution the card and camera should support. The hardware runs OK but only at the lowest resolution of 320x240. What is the highest resolution is supported with this set up? Does it support multiple cameras with different resolutions (eg: a 420TVL and a 600TVL cameras)? Thanks all. Share this post Link to post Share on other sites
tomcctv 190 Posted April 18, 2012 Hi. its a CIF card anyway. so not much you can do unless you change it. Fetaures : 4 Camera Security PCI Card. Compression : MPEG4. Display Resolution: 352 x 240 (NTSC). Screen Display: 1/4/7/10/13/16 multi-view or full screen. Network: Remote Monitoring and Recording with Search and Playback. Upgradeable - 4 cards in a PC for 16 cameras. Minimum PC capability: Pentium III 800 MHz or equivalent. Share this post Link to post Share on other sites
wildwind 0 Posted April 18, 2012 I thought it was the DICO-800 software not supporting the higher resolution. I just worked out it displays at 768x576 PAL or 640x480 NTSC but only records at PAL 352*288(CIF) NTSC 320*240 (CIF). How do I find out it actually displays at the higher resolution because it only detected as a 320x240 camera? Cheers. Share this post Link to post Share on other sites
tomcctv 190 Posted April 18, 2012 It is suppose to support 768x576 PAL or 640x480 NTSC as below. hi. same question was asked 4 years ago. viewtopic.php?t=17609 Could it be the 600TVL is a fake or lower spec camera from Chine? camera will have nothing to do with it. http://wiki.robotz.com/index.php/Pico_Install_Instructions_4_Port_CCTV_DVR_Card but you are on 800 software (which is cif) Share this post Link to post Share on other sites
wildwind 0 Posted April 19, 2012 Thanks for your help. " title="Applause" /> " title="Applause" /> " title="Applause" /> Share this post Link to post Share on other sites
