Help need to set up a Panasonic WV-CS320

[Fluke 0]

Hello Guys

 

I am new to this forum and would like to say big hello to all of you.

 

Right down to the nitty gritty

 

I have 2 units of the Panasonic WV-CS320,

The link below will take you too a PDF version of the user manual.

 

http://www.ecdltd.com/manuals/panasonic.pdf

 

I can get power to the unit fine and the video output is also fine, problem I have is how to I set the camera up it is currently doing a 360 pan and I need to edit this plus other settings.

 

How do I get to the setup menu?

 

According to the manual I should use a controller to enter the menu, this is the problem I do not have one.

 

Do any of you have any experience with this model?

 

This link http://www.info4security.com/story.asp?storyCode=1038157&sectioncode=9

states that the video cable also carries telemetry data I have split open the unit and can see at least 14 cables however a visual inspection along with a continuity test confirm these do not enter the camera unit.

 

Any guidance or help would be much appreciated.

[Fluke 0]

Reading further into this I believe that the coax cable send the video AND the telemetry date through the SAME cable.

 

I am now hooking up a controller to see if I can access the setup menus.

 

Please still reply if you can offer any guidance.

[Fluke 0]

I am heading in the right direction now further reading after searching "coaxitron" make the matter a lot clearer.

 

Is there an adaptor I can use to connect these panasonic camera to the following controller?

 

http://www.meritlilin.co.uk/assets/Keyboard%20Controller%20(PIH-800II).pdf

 

Or am a barking up the wrong tree?

[rickymok 0]

The Panasonic WV-CU161 System Controller or INNOTEK IT-CCU161 Camera Controller is recommended.