pikach 0 Posted April 26, 2012 I tryed to update the firmware on one of my Geo cameras and it failed, after I did a restore to default thru the web page on camera I cannot login to camera. Camera does not show on IP Device Utility between my devices, I try'd to reset it thru the camera reset button several times, I see the camera on its default ip 192.168.0.10 in my router among other connected devices, i can successfully ping the ip, but cannot connect to it whatsoever in IE nor in chrome etc. any help? Share this post Link to post Share on other sites
pavel1883 0 Posted April 26, 2012 That is all:-) you should go to the repare center. Share this post Link to post Share on other sites
pikach 0 Posted April 26, 2012 That is all:-) you should go to the repare center. Is there even a repair center for geovision? they dont even have a number for customer support.... only live chat that's always offline... Share this post Link to post Share on other sites
Korgoth Of Barbaria 0 Posted April 27, 2012 You can try one last thing, hold reset button while starting up camera for about 45 - 60 seconds, if that dosnt help, it's dead :/ send it back to support, they should send you a new one. Share this post Link to post Share on other sites
pikach 0 Posted April 27, 2012 You can try one last thing, hold reset button while starting up camera for about 45 - 60 seconds, if that dosnt help, it's dead :/ send it back to support, they should send you a new one. Did that already several times. No luck. Share this post Link to post Share on other sites
