rey 0 Posted May 10, 2012 is there a connector or converter that can change VGA or BNC to Spot output? We have 1 DVR,but two moniters,one at office,another in the shop, when reviewing the video,it also displays in the shop moniter, how can we stop this? Thank you. Share this post Link to post Share on other sites
Soundy 1 Posted May 10, 2012 Short answer: No. You can't send two different views out the same output. You could display a single camera on the shop monitor by splitting that camera's feed into the DVR... or you could add a quad or multiplexer to generate a separate display for the shop. Or you could upgrade to a DVR that actually has a spot output. Share this post Link to post Share on other sites
rey 0 Posted May 11, 2012 Short answer: No. You can't send two different views out the same output. You could display a single camera on the shop monitor by splitting that camera's feed into the DVR... or you could add a quad or multiplexer to generate a separate display for the shop. Or you could upgrade to a DVR that actually has a spot output. Hi,Soundy,thanks for the reply. We know the 2nd and 3rd solutions. but what did you meany by spiltting the camera's feed? what is this? Best Regards Rey Share this post Link to post Share on other sites
Soundy 1 Posted May 11, 2012 Where the camera plugs into the DVR, add one of these: Then run another cable from there to the other monitor - that will let you display that one camera separately. Share this post Link to post Share on other sites
rey 0 Posted May 22, 2012 hi Soundy, thank you very much for the reply. the "T" BNC is good,but we have 11 cams in the shop. We may try another DVR with spot. Thanks again, Share this post Link to post Share on other sites