usmanmunir 0 Posted June 25, 2012 Dear Friends, I have installed a Vicon Camera the video was coming fine. Then i change some DIP switch to make is Serial Connection with RS422 Support and i am using Pelco D to communicate with it. But when i reinstalled the camera. I see the movement in camera but no video on my PC. The Camera is connected through NVTs to Encoder. I also Noticed that Camera lens is moving around 360 degree as it move when it starts after 2 mins time. Can any body help me in this please Share this post Link to post Share on other sites
ferdzff 0 Posted July 10, 2012 hi friend, i have same problem last week where 2 espirit pelco camera connected to 2 pelco net was taken out and i connect it to CNB DVR. the configuration is Pelco D and i use RS425 2 wire. i changed one camera to address 2 as both were configured on address 1 before. when i move the PTZ suddenly the video comes black and i noticed that when i move the PTZ 1 PTZ 2 is also moving. I read the manual and the correct settings is Pelco P i change both the configuration on the DVR and the video comes back. one suggestion i can say is to read the manual of the camera maybe you have some wrong settings that is why the video was lost. Share this post Link to post Share on other sites