EarlT 0 Posted July 10, 2012 Is there a way to configure a WV-CS954 for Pelco P control? Share this post Link to post Share on other sites
rickymok 0 Posted July 24, 2012 The Panasonic WV-CS954 doesn't support Pelco protocol, it must control by Panasonic protocol controllers. So, you are recommended to use Panasonic WV-CU161 System Controller or INNOTEK IT-CCU161 Camera Controller to control the camera. Share this post Link to post Share on other sites
EarlT 0 Posted July 25, 2012 Can that CU161 then be controlled with another system like Avigilon? Share this post Link to post Share on other sites
rickymok 0 Posted July 25, 2012 No, only work for Panasonic products! Share this post Link to post Share on other sites
EarlT 0 Posted July 25, 2012 rickymok said: No, only work for Panasonic products! Arggg, time to sell the 954. Thanks Share this post Link to post Share on other sites
rickymok 0 Posted July 25, 2012 The WV-CS954 is very good camera. But the system controller is too expensive. If you just use it for a single camera system the INNOTEK IT-CCU161 is a best choice. Share this post Link to post Share on other sites
