Gesualdo 0 Posted August 22, 2012 I have a new CNB xcm-24vf camera that I just installed, and about 45 min after install (just enough time to put everything away) it started to act like it was irising due to clouds passing over, no problem. this then gets faster. It then was flashing to a white screen and back to the picture really fast, it then when all white for a few seconds and finally went black. All within a couple of minutes. I didn't have any problems on bench before installing. After I took it down and put the old camera back up. I tested it again and it is still black screen. I have already set up a return and should have another camera tomorrow. Having said all that- What went wrong? Share this post Link to post Share on other sites
digiblur 0 Posted August 25, 2012 What is the voltage of the power with the camera in line and running (not on the bench)? Share this post Link to post Share on other sites
Gesualdo 0 Posted August 27, 2012 Sorry for not getting back about this, The camera was toast. Received the new one the next day and sent the defective one back. The new one is working fine. It set up a lot easier this time. Gesualdo Share this post Link to post Share on other sites
