pmb 0 Posted September 30, 2012 (newbie, please forgive ignorance of this subject) VSI-Pro is a tillscan interface to overlay epos sales data onto a camera image recorded onto a cctv recorder. I would like to collect the sales data from the serial port on the tills and input it to the VSI-PRO. This system was working but was shelved for a couple of years during a refurb. There are 2 tills Geller ET6600 (c/w internal serial interface board) Geller ET6800 (serial port on left side of till) There are 2 VSI-PRO tillscan interfaces (circa 2000) What I've tried and failed: Serial at till: pin3 = data +, pin5 = ground Serial at VSI-Pro: pin2 = data+, pin5 = ground 20M cable run using CAT5e cable VSI-Pro programming: REGISTER SELECT: (Tilltype) = Generic COMMUNICATIONS: RX baudrate = 9600 TX baudrate = 9600 parity = even databits = 7 (also tried 8.) handshake = off auto linefeed = off (also tried on) Can someone point me in the right direction, please? Share this post Link to post Share on other sites
