imya86 0 Posted January 4, 2013 Hi I have a problem with power connection (DC) to Pelco ICS300-CRV3A cameras. In camera's manual I don't found any information about power wires. Only found that these cameras supports 24VAC and 12VDC. But which wires for DC power connection ? The wires: Red Black Blue & Blue/White Brown & Brown/White Green & Green/White I try to connect RED wire as + and BLACK as - , but it doesn't work. Please help! Share this post Link to post Share on other sites
aruegger 0 Posted January 7, 2013 What power supply are you using (Model / Series)? "The ICS300 Series can be equipped with three options. The ICS300- AP adapter plate allows adaption to a 2 gang electrical box, the ICS300-SS sun shroud helps shield the unit from sun in outdoor applications, and the ICS300-COND allows the unit to be used in applications requiring conduit. All models are designed for either 12 VDC or 24 VAC operation. Each unit is provided with two quick-connect mating connectors with leads; one for 12 VDC and one for 24 VAC. Just select the appropriate connector for your application, wire the leads to your power source with wing nuts, and snap the connectors together – it’s that simple!" Source: http://www.hcwt.com/pelco/pelco-security-camera-ics300.pdf If this doesn't help visit Pelco's community site www.pelco.com/community and post your question w/ images and their tech support will solve your problem. Hope this helps. Share this post Link to post Share on other sites
imya86 0 Posted January 7, 2013 What power supply are you using (Model / Series)? "The ICS300 Series can be equipped with three options. The ICS300- AP adapter plate allows adaption to a 2 gang electrical box, the ICS300-SS sun shroud helps shield the unit from sun in outdoor applications, and the ICS300-COND allows the unit to be used in applications requiring conduit. All models are designed for either 12 VDC or 24 VAC operation. Each unit is provided with two quick-connect mating connectors with leads; one for 12 VDC and one for 24 VAC. Just select the appropriate connector for your application, wire the leads to your power source with wing nuts, and snap the connectors together – it’s that simple!" Source: http://www.hcwt.com/pelco/pelco-security-camera-ics300.pdf If this doesn't help visit Pelco's community site http://www.pelco.com/community and post your question w/ images and their tech support will solve your problem. Hope this helps. Hello! I use the 12VDC power supply, not original (not Pelco's). I found the solution. For ICS300 series the BLACK is - and WHITE/BROWN is +. Thank you anyway for your help! Even integrated heater in camera starts good, the proof in attachment:) PS: in Siberia now -40C Share this post Link to post Share on other sites