Retrieve password Micros Sprite Netview

[champagne_charly 0]

Hello,

 

I'm hoping somebody can help, Other than sending the DVR back into Micros I was wondering if somebocy could tell me how to unlock the pass from Hyperterminal/ similar.

 

I'd followed the instrucions I found here:

http://alex.threlfall.me.uk/?p=263

 

On the later NetVu connected DS2′s the firmware and bootloader are vastly different. However, they are also much simpler to reset.

Put the DVR into bootloader by pressing Cam2 when you select shutdown from the menu.

Connect to Serial 1 at 38400 Baud, 8,1,N,N, using a Null Modem Cable and watch the DVR boot up. You should see lots of text go by. Eventually, this will stop, and you can press +++

Then issue the command “Userdef” and the passwords are reset.

 

unfortunately I tried and failed.

 

I enter hyperterm >

get the boot log after reboot using cam2. >

wait until bootlog finished then Type "+++" >

Type Userdef > Returns "?:" with a list of prompts as though it expects a further command.

enter "QUIT" and reboot returns message Loader 20 mins before start.

Reboot & press menu and again am asked for the password.

 

Anybody any thoughts? Advice?

 

Thanks

[treborsz 0]

The procedure, which quoted, applies only to the model DS2 NetVu (M2IP).

If you have a different version of the Digital Sprite (DVTR, DVTX, DVTU) - password reset procedure is different.