lenz 0 Posted March 7, 2013 Hi There, I have an issue that is taking me for a spin wondering if anyone has had this problem. I have An everfocus 16 channel DVR (EDVR16D1)there are 6 pelco PTZ cameras connected using pelco P 2400 baud rate. I can’t get (2) of the cameras to respond I have checked my setting over. I can control them through my service monitor but when I connect them to the DVR they don’t work. I have gone setting by setting and they are the same. I have disconnected all the other PTZ,s and connected the none working PTZ cameras one by one to the DVR without any luck I am thinking that it could be the DVR. Lenz Share this post Link to post Share on other sites
shockwave199 0 Posted March 7, 2013 If you hooked them up to channels where the other ptz's are working, I would think it's the ptz's that may not be working. Share this post Link to post Share on other sites
kongaleti 0 Posted April 28, 2013 either the cameras are faulty or videoin channels on DVR are faulty. Test them step by step. Usually diodes of input video channels gets damage or burn, due to which the video signal coming in to that channel doesnt get processed by DVR and hence no output on monitor. Share this post Link to post Share on other sites
vector18 1 Posted April 28, 2013 You should check the data wires for continuity, or bring the camera to the DVR and wire it up with a few feet of wire. Or, swap PTZ's out and see if the working PTZ stops working in the non working spot. It's a pain in the balls, but you need to use process of illumination. Share this post Link to post Share on other sites
