ACTI KCM-5611 URL Commands

[EarlT 0]

I noticed in the System Information page on my KCM-5611 it shows PT_ENABLE=0. I don't see anywhere in the menus to change it. I tried using http://192.168.0.2:80/cgi-bin/system?USER=*****&PWD=******&PT_ENABLE=1

 

Is there a doc that list all the valid URL commands? I did read through the

ACTi_Camera_URL_Commands PDF from the ACTI site, but didn't find any help.

[blakem 0]

On the system info page there is a button at the bottom for a full parameter list. In that url commands guide you found I believe it says somewhere in there that it only covers the mostly used parameters and is just a guide to show how to build the url command. I am not sure what PT_ENABLE controls but maybe it is a parameter of the encoder cgi and not system cgi. Have you tried http://192.168.0.2/cgi-bin/encoder?USER=*****&PWD=******&PT_ENABLE=1

 

What message does it return once you submit the url command?

[EarlT 0]

I did try both encoder and system. No luck with either. I was able to use commands for turning off the internal ir ring and power led so I know it does take "proper" commands.

 

I assume I would still use rx+/rx- for control out?

[EarlT 0]

Silly me. Switched to the TX+/- and it works.