robg172 0 Posted May 2, 2013 Hi all, I'm pretty new to camera installations and I'm planning to install a Dahua IP dome camera (IPC-HDW2100) onto a side brick wall. I need to feed the female RJ45 connector through the wall (for connection inside the loft space). The trouble is - the connector is around 30mm diameter and I'd need a fairly long and wide drill bit to get through the layer of brick and masonry. Question - how does everyone else get around this? Can the connector be cut off and re-terminated the other end without degrading video quality? Any guidance would be appreciated. Thanks Rob. Share this post Link to post Share on other sites
vector18 1 Posted May 2, 2013 You can either mount the camera on a back box and put the connectors in the box, outdoor of course, or drill your long hole with a skinny bit, than take a short fat bit and drill a big space on the brick and put the connectors in that space. Make sure you silicone any space where water can get to the connectors. Share this post Link to post Share on other sites
robg172 0 Posted May 2, 2013 You can either mount the camera on a back box and put the connectors in the box, outdoor of course, or drill your long hole with a skinny bit, than take a short fat bit and drill a big space on the brick and put the connectors in that space. Make sure you silicone any space where water can get to the connectors. Perfect, thank you for the tip. Share this post Link to post Share on other sites
bigglebowski 0 Posted May 2, 2013 Making your own cat5 connections can be easy once you have done a few, if done right there will be no compromise in quality. Drilling a smaller hole in masonry is always ideal especially when its a dense tough wall. You may even be able to just drill through the mortar lines depending on the makeup of the wall. Share this post Link to post Share on other sites
vector18 1 Posted May 2, 2013 I think he meant the connector on the camera if I read correct.. Share this post Link to post Share on other sites
shockwave199 0 Posted May 3, 2013 Camera manufactures need to get it- make the pig tail able to unplug to ease install. Otherwise you're stuck making a hole in the wall the size of an elephant instead of the size of network cable. DUH. Share this post Link to post Share on other sites