crow 0 Posted May 9, 2013 hi when i use the bnc output from the dvr to a phono adaptor to a tv's phono socket its always slightly blurry is this always the case thanks Share this post Link to post Share on other sites
bigglebowski 0 Posted May 9, 2013 Any time you use adapters you do have a little bit of signal loss but probably not enough to be very obvious. Blurry is the kind of description that can mean different things for different people, are you sure camera is in focus? Is this a flat panel TV, obviously SD does not look as sharp as an HD signal would be and often would look better on a CRT type monitor than and LCD/Plasma. Share this post Link to post Share on other sites
GrouchoBoucho 0 Posted May 9, 2013 it's probably because the bnc out is 640x480 composite video, which your tv is then up-scaling to its own resolution, and stretching to fill the screen. this is to be expected. Share this post Link to post Share on other sites
the toss 0 Posted May 9, 2013 It is also likely that the BNC o/p is 75^ while the RJ socket is 100^ Share this post Link to post Share on other sites
crow 0 Posted May 11, 2013 thanks for your replys yes must be the upscaling as its a 50 inch hd plasma with a high res a lot higher than 640x480 thanks for clearing that up Share this post Link to post Share on other sites