Cannot login with guest or admin, need to hard reset.

[tampabaycc 0]

I have a dvr of unknown brand. When i placed a order for it about 2 years ago i put in hard drive , tested it to make sure it works.

 

Apparently any password it had that the manual stipulated worked at one time, but does not now. I dont know if I changed it and forgot it, but seems there should be some way to hard reset it manipulating the motherboard or something.

 

I went to set it up today and no password works.

 

2408sv is on a sticker at bottom

upc code reads 6904420120215

 

also across the top of the middle circuit board it says

VB9708 Ver:3.0C 3030440133 244-m4c2972A0

 

I took the cover off and found

DVR-MB-178(a)

2011-11-19

on the botoom right of the circuit board.

 

 

 

the interface is this when hitting menu or right clicking.

 

the manual says the password should be 88888888 and this does not work.

 

 

 

I have no contact number in the book, or anything , seems like some generic dvr manual for 4/8/16 and says H.264 and thats it.

 

I have tried all the typical 123456 , 111111, 888888 and im litterally sitting here just going thru numbers trying to guess it, but is there anyway by lettering on motherboard to figure out what might be a master password?

 

 

 

Any help is appreciated.

[tampabaycc 0]

I took out the main motherboard to see what was on other side.

 

a bar code that said

178A11228051

 

Not sure if this will help or not.

 

Also took cmos battery out and am going to leave it out for over 24 hours to see if that will help.

 

I have read that "Shorting out the battery" would work, but I do not see on the board where i would be able to do this, what would be the area where I know that it would short right? I dont see any jumpers or anything.

[Manta 0]

When you click "Main Menu" does it display a Username and Password prompt? If so, is there a default username already in the field? The password can sometimes be the same as the username.