chomps 0 Posted July 5, 2013 Hi, I was given 3 of these units of which two work. I cant figure out what the passwords are to go into the admin to setup the cameras and network interface. I have figured out that by pressing menu it asks for a password 1 + gives me manager mode 2 + gives me user 1 mode 3 + gives me user 2 mode , etc Is there any way to reset this unit to default and what would the installer password be? I have attached some pics of the unit and I find no visible brand or make only on the main board it says SDVR16J Ver 1.1 And on the bottom it has 16JM535S Any help would be so appreciated as I have been at it for 3 days now Share this post Link to post Share on other sites
tomcctv 190 Posted July 5, 2013 Hi For admin its admin and no password (leave password blank) manager with 1 as password user with 1 as password Share this post Link to post Share on other sites
chomps 0 Posted July 5, 2013 Hi, Thank you for your prompt response. I take it you are talking about through a web interface connected to the network interface. I cant acces it as I dont know what the IP is and it doesnt show up in my dhcp range. I only have access to the front panel. I cant press admin on the front panel. I attached what it gives me on the monitor. Share this post Link to post Share on other sites
chomps 0 Posted July 5, 2013 Hi, Ok somhow I pressed The only thing now is to change the password it requires the current (or default) one and then you can enter your own and repeat to confirm. I have tried 1111, left it blank, 4888, etc as I see on most other forums but not alowing me to change it. It says current password incorrect. hhhmmmm...well at least I have come this far...still hoping for a default password if anyone knows it as I have managed to reset the unit from this menu. Regards Share this post Link to post Share on other sites
tomcctv 190 Posted July 5, 2013 I take it you are talking about through a web interface connected to the network interface Hi. no don't via DVR front buttons menu twice is admin. ..... of if updated (2007) menu 1234 then menu Share this post Link to post Share on other sites
chomps 0 Posted July 5, 2013 Hi, That doesnt work menu twice takes me into the menu and out of it again menu 1234 menu does the same as above. I dont have a remote. only front panel buttons. I managed to get into the config and set it up via dhcp it gave me the IP of 192.168.1.121 and port 50000 I tried this in my browser but it just times out. I can ping it on this IP too now. (Is there maybe special software I might need. I use Ubuntu linux on all my pc's) I changed the IP to 192.168.1.80 and port to 22000 I can telnet to it now on that but still nothing from a web interface Share this post Link to post Share on other sites
chomps 0 Posted July 13, 2013 Please anybody... any help here Share this post Link to post Share on other sites
