CCTV System design for Two IP PTZ Cameras

[goodie 0]

Friends, This CCTV System is for Oil and Gas app.

 

I have two IP PTZ Cameras which will be installed in field, whereas the main equipment will be installed in the control room which is about 400 to 500 meters away from this two cameras and the mode of connection between is FOC.

 

So can any one advice what are the equipments required to make a complete system and connectivity between them. (Please also provide the models of equipment, which is highly appreciated).

Please note that this system is IP CCTV system.

 

As per my understanding I need

1. Two IP PTZ cameras (Pelco) -for field area

2. NVR to record 30 days (DSSRV-005; 500GB)

3. HP 2610 switch.

4. Joystick controller.

5. PC with 32" monitor.

 

Please give your suggestions, as per your understanding which can make a complete system functional.

 

Regards.

[ferdzff 0]

Hi Goodie,

 

You are using 2 IP cameras right? so there is no need to use a Fiber optic cable use a TP link outdoor antenna 2 each total of 4 then align both of them point to point then plug it to the router connect it to pelco NVR then attached your KBD 500 joystick. If in case you have already layed down a fiber optic from the area where the camera will be installed going to the communication room you need to use a converter. Here is the link below.

http://www.bb-elec.com/Products/Datasheets/EIR-x-Sx-series-1012.pdf

[goodie 0]

Thanks ferdzff.

 

I have found the converter from pelco itself .

 

Model FX82011 Ethernet Media converter.

 

thanks again.