taayyaabb 0 Posted December 8, 2013 A.A I have AVTECH 798 DVR and ptcl AN1020-25U router and a static ip .. i have forward two ports 5100,80 and in dvr i give the port 5100 now DVR working fine on local network but i can't acces it by static ip .. plzz reply fast thnks Share this post Link to post Share on other sites
fertilebert 0 Posted December 8, 2013 Fast reply , you're doing it wrong! Share this post Link to post Share on other sites
taayyaabb 0 Posted December 8, 2013 what's wrong plz explain Share this post Link to post Share on other sites
tomcctv 190 Posted December 8, 2013 what's wrong plz explain how are you testing external IP ...... in some cases you cant do it on your own network Share this post Link to post Share on other sites
aibudo 0 Posted December 8, 2013 You said that you set your static IP, but I just want to make sure that you have the right address's for the right places. There are two IP addresses that you need. The LAN address, which is your network address for the DVR and the one that you want to static for sure. What about your WAN address? Did you check your WAN address by going to "whatismyip.com"? That 's the address that you will need to access outside your LAN. That address can change over time, if your ISP decides to do so, unless you have a static address with them also. Your ISP can also block port 80 and give you an issue. Your ISP can also have security setup as such that you can't use your WAN address to access the DVR. Have run into that before and the ISP had to setup another WAN address just for the DVR itself to get through/around the router. Share this post Link to post Share on other sites