Jump to content
taayyaabb

DVR Networking problem

Recommended Posts

A.A

I have AVTECH 798 DVR and ptcl AN1020-25U router and a static ip .. i have forward two ports 5100,80 and in dvr i give the port 5100 now DVR working fine on local network but i can't acces it by static ip ..

 

plzz reply fast thnks

Share this post


Link to post
Share on other sites

You said that you set your static IP, but I just want to make sure that you have the right address's for the right places. There are two IP addresses that you need. The LAN address, which is your network address for the DVR and the one that you want to static for sure. What about your WAN address? Did you check your WAN address by going to "whatismyip.com"? That 's the address that you will need to access outside your LAN. That address can change over time, if your ISP decides to do so, unless you have a static address with them also. Your ISP can also block port 80 and give you an issue. Your ISP can also have security setup as such that you can't use your WAN address to access the DVR. Have run into that before and the ISP had to setup another WAN address just for the DVR itself to get through/around the router.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×