jezfff 0 Posted December 11, 2013 Hello all. I have setup an Avtech DG1648 (16ch) today (not the most up to date system, I know). All is well and good, except after making a change in the remote settings - specifically changing the motion detection area - the system will no longer respond to menu commands, eg changing camera channel or going from displaying one camera to a block of 16 (or 9, or 4). It just ignores the commands. The system continues to show live camera feeds so it has not 'crashed'. I have to do a power cycle to make it respond again. Am I doing anything wrong, is there something I can do? Thanks in advance. Share this post Link to post Share on other sites