Scottish 0 Posted December 13, 2013 Hi Guys, new here so be gentle, Using NUUO Titan 4040 for the first time and having real trouble getting a Arecont 20365DN to record smoothly on Motion it appear to be adjusted fine on the camera software and when I go back to the NVR its going off VERY randomly. I have worked on Milestone, Geovision and the software controls the motion on this NUUO its the camera. Anyone had any issues or solutions? Many thanks, David. Share this post Link to post Share on other sites
ssnapier 0 Posted December 13, 2013 In the supported camera list it has this note for your camera: On-edge motion: turn off the "enable extended on motion detection" function on camera web. I am guessing they mean on the camera's web interface. Good luck! I have used a few NUUO things in the past, and they were a bit funky at first, but once you get them sorted they are quite reliable. I would also make sure you have the most current firmware on that camera. Share this post Link to post Share on other sites
Scottish 0 Posted December 13, 2013 Thanks Mate, I noticed that and turned that off last week and upgraded the camera firmware, the NUUO tech updated the NVR firmware, the NUUO tech and the Arecont Tech just keep blaming the other its a real time wasting set up. Share this post Link to post Share on other sites
ssnapier 0 Posted December 13, 2013 Any chance you can post videos of what the camera does vs. what it does inside NUUO? Share this post Link to post Share on other sites
