sachida 0 Posted December 16, 2013 Hi Very new to CCTV camera and just purchased three DS-2CD2032-l I have to use power over Ethernet adapter for two locations as I dont have ethernet outlet in the exterior of the home. I tried setting it up as shown in the network map below but could not find the camera with included software (SADP). To trouble shoot I have done following 1. checked the poe connectivity for internet with laptop and its working 2. directly connected camera with desktop with LAN cable but camera does not show up on SADP software 3. repeated #2 with laptop still no connectivity. Unclear how to troubleshoot from this point on. I thought the camera were POE and so does the sticker on the camera say. But so far not working just with ethernet connection. Please advise May be I need poe injector somewhere in the scheme? please advise Share this post Link to post Share on other sites
MikesCams 0 Posted December 16, 2013 The Hikvision 2032's come with a fixed IP address of 192.0.0.64 so you may need to configure your PC with a compatible IP. You may also need to disable any firewall. Share this post Link to post Share on other sites
sachida 0 Posted December 16, 2013 Talked to HIKVISION tech support. They suggested using poe injector. It has to be post ethernet over power adapter. I ordered tplink one from amazon. will update with results Share this post Link to post Share on other sites
JoeyJoey 0 Posted December 24, 2013 The camera is POE. Use a network switch that has POE built in. Use the SADP windows tool to set the IP address, no need to change the PC ip address. Share this post Link to post Share on other sites
MikesCams 0 Posted December 24, 2013 Make sure you have the latest version of WinPcap installed for SADP to properly see the camera. Share this post Link to post Share on other sites