jeromephone 6 Posted January 11, 2006 I have two PTZ cameras at a cusomers one is about 3 years old and the other is new I have them set at 9600 baud pelco P and they have addresses 1 and two I cannot control them from the same control board but I can hook up a seperate controller enter the address and it works fine. the supplier is willing to send me a new camera but changing them out will not be easy. I could use the geovision box but the customer does not want to do that. Any idea why the two cameras don't work when using the same controller? Share this post Link to post Share on other sites
scottj 0 Posted January 11, 2006 What controller are you using? Also what DVR controls are you using, brand of DVR etc. What model PTZ's? Scottj Share this post Link to post Share on other sites
RVRBOY420007 0 Posted January 11, 2006 Sounds like a protocal issue. Definatly need to know what the ptz models are. If the dvr controls one on pelco p and the new ptz works on pelco p then there shouldn't be a problem I would double check the setting and specs. Share this post Link to post Share on other sites
VST_Man 1 Posted January 11, 2006 baud rate or termination Share this post Link to post Share on other sites
jeromephone 6 Posted January 12, 2006 Thanks will track down mfg do you mean the 120 Ohm termination on the last camera or do you mean a connector problem? Share this post Link to post Share on other sites
VST_Man 1 Posted January 12, 2006 last cam termination Share this post Link to post Share on other sites
