cs854 PTZ and Axis 241S question

[mike_va 0]

I am new to PTZ, and could use some advice.

 

I've tried to reset it per the manual, and confirmed per the screen shot attached.

 

I can not get my 241S or 243 to control it, just pans left to right non stop.

 

Any advice appreciated. Hooked up with 4 feet of wire on the 485 to yellow/green (and ground), half duplex terminated.

[adamxp12 0]

I am new to PTZ, and could use some advice.

 

I've tried to reset it per the manual, and confirmed per the screen shot attached.

 

I can not get my 241S or 243 to control it, just pans left to right non stop.

 

Any advice appreciated. Hooked up with 4 feet of wire on the 485 to yellow/green (and ground), half duplex terminated.

For most ptz cameras you don't need a ground

The axis server should have the protocol set to "Panasonic" with an address of 1

[mike_va 0]

Thank you.

 

I recently got this working. It was an issue where the 485 had gotten cut under the taped up area. Once that was fixed worked very nicely.

 

Nice how you can pan etc by clicking on an area of the screen, zoom with the mouse wheel etc.