Kevin75135 0 Posted January 31, 2014 I purchased a GeoVision GV-FER521 system to install on my GV-NVR. When I view the camera in default (raw) mode, PIP, or PAP mode, the image is fine, and I can see the full 360 degs.. However if I select Geofisheye view, no matter what view I select, the image stays centered on a particular area of the room. Any attempt to change the angle of view just results in the image spinning. In single view mode, the PIP image is a circle much smaller than my other fisheye cameras, and is sliced off on the side. In 360 deg mode, the bottom image which is supposed to show everything only shows about half of the image. I have tried setting the camera to different Fisheye cameras in the IP camera install utility, and my settings for camera position is correctly set to ceiling. Does anyone have any ideas on how to get this to work? My GV-FE2301 and GV-FE520s work fine. Share this post Link to post Share on other sites
