Jump to content
Sparr

Need help setting up a CCTV Joystick Controller

Recommended Posts

Hello,

 

I purchased a CCTV joystick controller recently on ebay and the manual was written by Chinese which is virtually impossible to understand. I contacted them and they are are equally impossible to understand. I am using a stand alone DVR with four 24V PTZ cameras. The DVR is currently set up and all cameras are working fine per the DVR. I would just like to get the joystick controller to work the cameras as it's much easier than using a mouse. There are several people selling this same joystick controllers on Amazon and ebay. Have any of you guys seen these or had the pleasure of setting one up? If so, I could really use your help. Thanks in advance, Chris

 

 

http://www.amazon.com/Joystick-Keyboard-Controller-Display-Control/dp/B00GLOF108

 

I'm not sure how to get the image to show yet here is a link to the image of the joystick controller.

Share this post


Link to post
Share on other sites

Ahhh Uncle Woo's PTZ Controller/

 

1. Set Baud to 2400

2. Connect 18/2 + &-

3. Power up PTZ. Watch during bootup for baud and address ID & protocol. Does it match? By default PTZ controller are Pelco-D protocol & 2400 baud.

4. Enter 1 Cam or Cam +1 on eyboard till display shows the 1 camera

5. Can you control it?

Share this post


Link to post
Share on other sites

Hello and thanks for the response! I am getting ready to attempt to work on the PTZ controller again. The directions are absolutely horrible!! How would I switch the controller to work other cameras? I found the setup where I set the protocol and baud rate, just don't understand how to get the controller to control the cameras. Your help is very much appreciated:)

Share this post


Link to post
Share on other sites

Hello again Varascope,

 

Your advise worked like a dream! Amazing how they couldn't put that in the manual... As soon as I hit cam # and cam, the controller immediately responded. Now, how do I set up the controller to sweep? I'm sure it's simple too, yet I tried a few things and no luck. Your help is really appreciated, Chris

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×