Jump to content
Sign in to follow this  
jingo

Dennard 460 pan/tilt head wiring

Recommended Posts

Hi guys,

 

I recently acquired a piece of cctv history, namely, a Dennard 460 pan tilt head.

 

I would like to wire this up to two 240v momentary toggle switches (on-off-on) for testing purposes and these will be replaced later by relays (240vac rated) and controlled remotely, but I don`t have a clue how to wire it. The wiring at present is fed into a Dennard 506 housing (amphenol connector) where its linked to the camera and wiper/heater, then exits the housing and connects to the actual pan tilt head (amphenol connector).

 

I have uploaded a number of photo`s which I hope will help, one of which shows the housing interior and a choc bloc which has two purple wires, one of which connects to nothing other than the head at the other end; why is this?, also, the red and brown, yellow and white wires are twisted together, is there a reason for this (up/down & left/right possibly)?

 

These Dennard pan/tilt heads really are a good, solid bit of construction, and, besides cctv use, there must be other unrelated projects these parts can be used for - besides a door stop or anchor?

 

Any help and advice would be greatly appreciated and I would like to thank you all in advance.

1233702950_Dennard506housing.thumb.jpg.4b634a794252dc8f904e99f53942638c.jpg

1545744896_Amphenolconnectortohead.thumb.jpg.375761522125e55d72800a5ebae7f711.jpg

951691408_Dennard460internalconnections01.thumb.jpg.5f587319f2bd4478f1fdb1f21acc57f2.jpg

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×