matrix733 0 Posted March 25, 2014 Hello all, I have a DNT L3108HV DVR, its this one located here http://www.dnt-cctv.com/en/productsDetail.aspx?id=262 . I sent it back once for some power issues and the seller upgraded the power supply and firmware to the latest one on the DNT website. I recently noticed it was not keeping the correct date and time and that only two channels is displayed. I unplug the unit and took it home to troubleshoot further but it still display only two channels instead of the eight and it will not show any cameras on either channel. I have changed the battery and it now keeps time but still only allow me to see two channels. I verified the cameras are working when plugged into a another monitor and I re-flashed the unit with the firmware from the DNT website but still no go. I have unplugged the hard drive and re-flashed several times but it still boots up to two black channels and I can navigate through the menus but it still shows only two channels to configure versus the normal eight. Anyone have any ideas or similar firmware to flash. I am about to order one of the newer 960h DVR but would hate to do so if a re-flash would fix this one. Any insight would be appreciated, thanks. I also contacted the seller again but did not get a response as of yet. Share this post Link to post Share on other sites
matrix733 0 Posted March 25, 2014 Just thought I would let you all know that I just heard back from the manufacturer who said that since it is showing only two channels that means a chip on the motherboard has burnt out and they don't repair because of cost compared to a new unit. I had a hunch and ordered a new DVR so I should be back in business in two days... Share this post Link to post Share on other sites
