Camomille 0 Posted April 30, 2014 Hello, I have to install analogue wired cams where using balluns & cat cable is impossible due to site nature. Can you recommend me a good 5.8 MHz wireless transmitter:receiver ?* I read here that you like Ubiquity Airmax devices. This could be a good and not expensive alternative but I don't know how to turn the coax video signal into ip ( and from ip back to coax). Great thanks for guiding me Greetings to all. Camomille Share this post Link to post Share on other sites
jeromephone 6 Posted May 1, 2014 it may be cheaper to go to a nvr/dvr combination unit and just use IP cameras you would have to decode on end and encode the other end to use analog. I don't know if all your cameras are wireless or just a few Share this post Link to post Share on other sites
Camomille 0 Posted May 4, 2014 Hello, great thanks for ypur answer and sorry for my late reply ! You gave me a goood idea I still have a Avermedia NV748 16 ch hybrid card I can use! All my cameras are "wired". No ip- wireless- cam ! I was looking for a wireless or ip solution for the cameras located at about 80 meters from my office with parkings or macadam ways between. I cannot use coax neither go under the asfalt for cabling these cams I think I still need to find a good device to convert the video signal for tranmitting using a Ubiquiti Airmax 5.8 ghz !! Great thanks again for your answer and the good tip Greetings to all. Camomille Share this post Link to post Share on other sites
hardwired 0 Posted May 4, 2014 You could use an encoder/decoder pair like the Acti TCD-2100 encoder, and the ACD-3100 decoder, but the cost of those would be higher than using an IP camera, rather than an existing analog camera. You mentioned that you have a hybrid capture card, you should check to see what IP cameras are supported by it. Share this post Link to post Share on other sites
Camomille 0 Posted May 4, 2014 Thank you for guiding me !! You're right about the cost of Acti encoder & decoder !! I found that the card supports many cameras. IP Cam Support - AXIS, SONY, Panasonic, Areconl, Mobotix. BOSCH, IQinvision, JVC, TOSHIBA, VIVOTEK. ACTI, D-Link, PiXORD, PELCO, Apron, Lilin and more I will rebuild a working PC DVR system and investigate once it is operational! You really helped me a lot. GREAT THANKS again Greetings to all. Camomille Share this post Link to post Share on other sites
