Dedicated Micros 2060

[00matt 0]

Hi

 

I have just aquired a brand new DM 2060 dome, specifically the DM/2060-241, and set it up with presets with varying zoom levels. When calling a preset, the zoom operates at a consistent rate until right at the very end where it slows down for approximately 1 second and then jumps (speeds up) to its preset zoom point. Im not sure if this is normal behaviour as I have used other PTZ cameras that zoom at maximum speed all the way to their preset points without slowing down. Could anyone who has experience with these domes advise if this is normal?

 

Thanks,

 

Matt

[adamxp12 0]

Hi

 

I have just aquired a brand new DM 2060 dome, specifically the DM/2060-241, and set it up with presets with varying zoom levels. When calling a preset, the zoom operates at a consistent rate until right at the very end where it slows down for approximately 1 second and then jumps (speeds up) to its preset zoom point. Im not sure if this is normal behaviour as I have used other PTZ cameras that zoom at maximum speed all the way to their preset points without slowing down. Could anyone who has experience with these domes advise if this is normal?

 

Thanks,

 

Matt

I dont have a 2060, but I do have a 2055 and I do not have issues like this

it zooms in at a consistent speed

[00matt 0]

Hi

 

I have just aquired a brand new DM 2060 dome, specifically the DM/2060-241, and set it up with presets with varying zoom levels. When calling a preset, the zoom operates at a consistent rate until right at the very end where it slows down for approximately 1 second and then jumps (speeds up) to its preset zoom point. Im not sure if this is normal behaviour as I have used other PTZ cameras that zoom at maximum speed all the way to their preset points without slowing down. Could anyone who has experience with these domes advise if this is normal?

 

Thanks,

 

Matt

I dont have a 2060, but I do have a 2055 and I do not have issues like this

it zooms in at a consistent speed

 

Thanks. I think this must be a fault with the unit - will contact DM as its under warranty.