denis5069 0 Posted August 26, 2014 Hello I have a dvr 1694p-a brand new Bios version 2.608.0000.2 build 2011-5-27 Motion detection mode is set up Problem : the system always detect motion while there is none. Therefore the system akways reccord I have tried to change sensitivity from 1 to 6 Is there any adjustment that i missed Many thanks in advance Denis Share this post Link to post Share on other sites
mgb 0 Posted August 26, 2014 Make sure it's set right. There may be two places to set it. Such as you may have to enable it under each cameras setup but also in the schedule. Share this post Link to post Share on other sites
denis5069 0 Posted August 26, 2014 I am sure about settings But what i ser is that the video when it is dark is like there was water in it... Maybe this is what detect the dvr as motion.... Difficult to duscribe but maybe the signal is not stable enough? What can we do to stabilize this video signal especialy us dark condition. The camera is bosch true day night Thanks Share this post Link to post Share on other sites
mgb 0 Posted August 27, 2014 Hard to say without seeing the problem but maybe the connections are bad or you're getting reflection back from the ir LEDs. Share this post Link to post Share on other sites