jwarrior 0 Posted September 16, 2014 Hi guys, I tryed to update the system but the power of my house was down before the update ends. So now i only have the main logo when i start the mini nvr and he shows always the main logo i think he can´t boot, i attached the picture. Can someone help me how i do to reset or recovery the mini nvr? The only way is with Tellnet? i am not IT expert can someone explain send me a video with instructions or the steps? I wait for help. Thanks Share this post Link to post Share on other sites
Frazer 0 Posted September 17, 2014 I have just done exactly the same the start screen comes up but then nothing. I cannot ping the device. I also cannot find anything on the internet about factory resetting it. Any ideas anyone? Share this post Link to post Share on other sites
tomimidi 0 Posted September 19, 2014 hi! I also encountered the same error last night. So far, 20140415 Xvision version was installed, which has flaws. I tried to upgrade the "01530123_mini_8ch_nor_A_old_20140417.update" file, but after the update and reboot only "Network Video Recorder" screen and turns off the video output. The 20140415 firmware three update file is, and this is just one file! This should not be a problem? Share this post Link to post Share on other sites
axolotls 0 Posted October 11, 2014 I have the same one. Worked for an hour. Now I can't even use the mouse when plugged into the unit. Share this post Link to post Share on other sites
