zgebis 0 Posted September 30, 2014 I am using the cheep pre made bnc cables that came with a Swann kit for my new cameras. The wire ends are so brittle from being moved that they are cracking at the spot where it enters the connector. I dont want to have to rewire the bad wires. Anyone have any solutions. This is at the DVR location and the dvr is shoved up in a closet on a shelf. I was thinking about making small bnc cables in 2foot lengths securing the connectors that are bad to the wall so that they can not bend or get any stress on them when the dvr is being moved. Its a real wire mess at the dvr and every time I have to troubleshoot, there is a rats nest of wires because of the video and power is in the same cable. Id also have to have a male to female adapter in each connection also. What Ideas do you have? I think if the cables were tacked on the wall and just the new cable is all bound together in the same length they would neatly plug into the dvr without any wire mess. Share this post Link to post Share on other sites
jeromephone 6 Posted October 1, 2014 you can buy pre made bnc patch cables from 6 inches to ten feet In the past we have used a bnc patch panel and short patch cables it makes for a neater install but you do have added connections Share this post Link to post Share on other sites