Wiring an Olympus ME-52W mic to a Hikvision DS-2CD2732F-IS

[TheCameraManCan 0]

Thought I'd give a run down of how I wired up a Olympus ME-52W Noise Canceling Microphone to pick up audio for a IP camera, as it was a little different than what I read elsewhere.

 

Camera Details:

Model DS-2CD2732F-IS

Firmware Version V5.1.6 build 140412

Encoding Version V5.0 build 140411

 

Audio Tab:

Audio Encoding G.711ulaw

Audio Input MicIn

Input Volume 100

Environmental Noise Filter OFF

 

Video Tab:

Video Type to "Video&Audio"

 

------------------------------------------------------

 

To physically wire it up, I first snipped the male plug off the 3 ft microphone wire extension that came with the microphone.

 

Then, I wired the red wire to the "Audio In", and the green wire to the "Audio In Ground" slots as pictured below. Make sure to trim the insulating, jacket wire back so it doesn't come in contact with the mic wires!

 

 

A reboot after it was all set up, and I must say I'm pretty satisfied with the audio.