eXOBeX 0 Posted February 24, 2006 Does anybody know what the camera settings need to be in order to control a Pelco Spectra III from Diginet Site? I assume Pelco-D SD needs to be chosen on the PC, but it doesn't let you select the ID number of the camera concerned - Pelco D protocol supports 254 addresses set by DIP switches on the camera! Share this post Link to post Share on other sites
eXOBeX 0 Posted March 2, 2006 It's OK, I've sussed it now. The address should be set to the number of the camera within DigiNet Site, if for example you have three fixed cameras 1, 2 and 3, with a PTZ as camera 4, the Spectra's D-protocol address should be 4 (SW1-3 on). All other settings should be default (2400-N-8-1), termination should be switched on (SW2 on) if camera's at the end of the chain and if there's no 120 ohm termination resistor already on the plug in the housing. Share this post Link to post Share on other sites
