pig 0 Posted June 2, 2015 Hi, I have a 4 channel DVR which is set up so I can access it through my IP address from any outside computer. I also have another 4 channel DVR which I would like to set up in the same way. Is it possible to connect both DVR's to the same router and be able to access them both from the same IP address? If not then I might have to invest in one 8 channel DVR. Any help would be appreciated. Regards. Share this post Link to post Share on other sites
topchips 0 Posted June 3, 2015 Hi,I have a 4 channel DVR which is set up so I can access it through my IP address from any outside computer. I also have another 4 channel DVR which I would like to set up in the same way. Is it possible to connect both DVR's to the same router and be able to access them both from the same IP address? If not then I might have to invest in one 8 channel DVR. Any help would be appreciated. Regards. Hi All you have to do is change your http or server port on the other dvr, how are you connecting to the dvr? via cms software or browser? eg if your one dvrs server/utp port is 37777 make the other one 37779 and when connecting via you static or dyn use the corresponding port Share this post Link to post Share on other sites
pig 0 Posted June 3, 2015 I have changed the http ports but when connect through my static only one DVR shows up. What should I be putting into the address bar to connect to the DVRs? They both connect though browser. Regards. Share this post Link to post Share on other sites
topchips 0 Posted June 3, 2015 I have changed the http ports but when connect through my static only one DVR shows up. What should I be putting into the address bar to connect to the DVRs? They both connect though browser.Regards. You must use eg: http://192.168.1.20:90 the :90 must be the new port you change to Share this post Link to post Share on other sites
pig 0 Posted June 3, 2015 This is what I have been trying, however when I input this into internet explorer it says that it cannot display the webpage. Share this post Link to post Share on other sites
rmfjr78 0 Posted June 4, 2015 Do you have both ports forwarded in the modem/router? Share this post Link to post Share on other sites
pig 0 Posted June 4, 2015 I do and this is what stumped me. If I try my static IP address internally, it works fine. Externally it says that the page can't be displayed. Share this post Link to post Share on other sites
topchips 0 Posted June 4, 2015 I do and this is what stumped me. If I try my static IP address internally, it works fine. Externally it says that the page can't be displayed. go to www.canyouseeme.org and check if that port is forwarding, are you using the local static address or a public static address? Share this post Link to post Share on other sites
pig 0 Posted June 6, 2015 Public static address and canyouseeme.org says that it can see the port so I don't know what I'm doing wrong. Share this post Link to post Share on other sites