rmi63 0 Posted September 15, 2015 I have a question regarding the IR on these cameras. This morning, when it was dark, I noticed that the IR light was not on. It was late last night. I haven't really had a time to troubleshoot it but it is my understanding that the IR on these things are controlled by the camera itself and not by software. I think I read somewhere that the IR turns on and off automatically and there is no way to control this. Is this correct? Share this post Link to post Share on other sites
topchips 0 Posted September 16, 2015 Hi There you can check the setting on the camera to make sure DAY/NIGHT is on Auto,you will need to log into the cam via the IP address, see pic attached Regards Share this post Link to post Share on other sites
MaxIcon 0 Posted September 16, 2015 The older Dahuas, like the 3300 and 2100, had no direct IR control. IR was turned on and off by the sensor on the IR board; it didn't matter if the software was even running. I believe the 4300 series is controlled by firmware, but it's been a while since I tested it. Share this post Link to post Share on other sites
rmi63 0 Posted September 22, 2015 I ended up doing a factory reset and everything is working fine. Don't know what the problem was. Share this post Link to post Share on other sites
