gaz2313 0 Posted October 13, 2015 hi anyone out there have any info on these cams I have the user and installation info but I am looking for cct diagram if possible to find out what I have damaged the cam has 2 infra red units attached and at night the center of pic is too bright to view at anything under 50 mtrs and the infra reds just plug in to the board with a 5 pin connector so I had a bright idea just unplug one of the infra reds after I did that neither infra red worked nor when I re connected it so I guess its a bit more complex a setup and I have blown something the lead to the infra reds have 5wires red power + yellow -ve black and blue to ldr and green I don't know what this should have on it but I am guessing this is the control wire to turn the leds on and off any one any ideas I have tried vista tech support but they do not have any tech info just the user man on the board that the leds plug into there is an opto isolator and a comparator chip anyone know if these are easy to destruct by just unplugging a device and yes I did power down before disconnecting lol it just didn't like being powered up with only one connected Share this post Link to post Share on other sites
