tee-J 0 Posted October 28, 2015 Hello guys, I am using a ANNKE system. I port forwarded the BT business hub and put the subnet as 255.255.255.0 on the DVR. I put the gateway on the DVR same as the networks. Now I can access the DVR on the same network but cannot access it anywhere else. Canyouseeme shows that the port 8080 is not open even though its the DVR's port and I use that port to access it on the same network. I have used BT instructions to port forward. Thank you. Share this post Link to post Share on other sites
PHVideo 0 Posted October 28, 2015 Hi, Assuming you have HH5 go into the hub settings 192.168.1.254 >advanced (enter password and continue to advanced settings) >firewall>manage games and applications>add a new game or application> type a name eg: CCTV copy existing change to 'no' Protocol 'any' then enter the ports you need 8080 to 8080 click add then repeat for any additional ports required and apply when finished click on port forwarding again at the top of page game or application should be 'CCTV' and device should be user confined and enter the address of your DVR. Click apply and test your ports on http://www.yougetsignal.com/tools/open-ports/ You know that unless you have a static IP you will have to setup an dynamic dns account to keep the IP updated. But my instructions should help you open the ports needed Hope this helps. P. Share this post Link to post Share on other sites
tomcctv 190 Posted October 28, 2015 Hi, Assuming you have HH5 go into the hub settings 192.168.1.254 >advanced (enter password and continue to advanced settings) >firewall>manage games and applications>add a new game or application> type a name eg: CCTV copy existing change to 'no' Protocol 'any' then enter the ports you need 8080 to 8080 click add then repeat for any additional ports required and apply when finished click on port forwarding again at the top of page game or application should be 'CCTV' and device should be user confined and enter the address of your DVR. Click apply and test your ports on http://www.yougetsignal.com/tools/open-ports/ You know that unless you have a static IP you will have to setup an dynamic dns account to keep the IP updated. But my instructions should help you open the ports needed Hope this helps. P. Hi. Very well explained will help lots of people with BT hubs. As far as static IP goes business static IP is now free and in most cases now they don't change with business accounts Share this post Link to post Share on other sites