Jump to content
Sign in to follow this  
tkjourneyman

Troubleshooting a PELCO Esprit HD using balun has no control

Recommended Posts

Hello,

 

I'm having issues trying to figure out how to gain control of the camera listed in the link below, while it's using a balun. I have not used or installed any of these myself as I'm still new to the trade. The camera it's self has picture running to the monitor, but getting it to move has not been fruitful. I did not install this camera initially so this is totally new to me. I'm on this job by myself and assistance has been spotty at best. I have a couple of ideas aside from tearing it all apart and reinstalling everything according to the manual, but my current location keeps me very limited on supplies needed to make that kind of transition. Also the picture is only in IR and I am pretty sure it has daytime use for color picture.

 

Any and all help would be greatly appreciated.

 

https://www.pelco.com/ptz-ip-cameras/esprit-hd-high-definition-integrated-pressurized-camera-systems

Share this post


Link to post
Share on other sites

Hmmm this is an IP HD camera. Video balun is used for transmission of analog (composite) signal via twisted pair (UTP) and I don't think Pelco make CVI, TVI, SDI or AHD. Use the RJ45 (CAT5) to transmit video signal and data.

 

Good Luck!

Phil

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×