iamatemple 0 Posted March 20, 2016 A friends old system went down and to get it up till the new system came some wiring needed to be done. Locally I wasn't finding RJ11 to BNC converters so I made some. The cameras were A-CC3MH type in model number and similar A-c*** model numbers. All used RJ11 which went to a multiplexer that accepted that type of input. The multiplexer also had BNC output and converted the signal which then went to a DVR for storage. CCD camera 1 ---> RJ11 multiplexer input ---> multiplexer BNC output (of CCD camera 1) -----> DVR BNC input These cameras labelled "ADT" made in Korea didn't show up anyplace on the web that I looked. Turns out it seems they're made by Ultrak which I found looking for monitor/interphone in hopes of describing the connection type. A poster who I'm not able to credit mentioned they were able to get this type of camera to work using the following: RJ11 pin 1 = Power (-) - bare wire or shielding for video which is ground pin 5 = red - POWER (+) requires 12volt 1amp to work for me though says it can take 15volt 4w MAX DC pin 3 = white foam shielded copper - Video (+) goes to the BNC center pin / solid copper wire on BNC male pin ? = yellow wire which went to the BNC shielding for Video (-) I cut rj11 connector off and did what is below: CCD wiring (was RJ11)___________________BNC male connector_____________________Power source 12v-15v DC 1amp-4 amp MAX Green skinny wire (not used by me) Black skinny wire (not used by me) Yellow skinny wire ====================>> BNC shielding wire / outside of connector (Video -) Red thicker wire =============================================================>> Power source (+) white foam copper solid wire ===========>> BNC copper center wire / center pin (Video +) shielding wires from around white foam copper wire ===============================>> Power source (-) bare skinny wire =============================================================>> Power source (-) This had all the cameras up and working and thanks to flea markets and thrift stores the power supplies were reasonably priced and plentiful. Share this post Link to post Share on other sites