Access QVIS using IE on Windows 7 and 10

[Rudie 0]

Hi,

 

I can access my internal cameras using IE on Windows Vista using the internal and external addresses without no issue. I did initially have to change the security settings to allow unsigned certificates to be installed once prompted. I could never get Chrome to work though.

 

I have a Windows 10 machine now but when I try and access the cameras, I get the initial logon page as normal, once in, I get the console interface, but get the Quicktime 'Q' displaying where the CCTV images should be. I have made the changes to the security settings as I did previously but without no luck.

 

Does anyone know how to solve this?

 

Thanks in advance.

[Rudie 0]

Just reading, I will try and remove QuickTime and try again...

[Rudie 0]

i have de-installed quick time but the cctv doesnt load the streams. it keeps asking to install quicktime...

[Rudie 0]

I have started the ActiveX service too.

[tomcctv 190]

Hi. Can you post a picture of your menu on your qvis dvr to see which one you have .

 

Some will work with the dahua PSS software

[Rudie 0]

Sure will get some photos when I get home.

[Rudie 0]

Sorry for delay here are some pics...

[Ramiro 0]

I had the same problem, you should put in internet explorer settings> to allow all activex behaviour unless it says that it is unsafe, in which case you should set it to prompt. Later access http://yourip:yourport it is needed for you to put the entire address as this, and finally add to compatibility view this address.

Voila, it should now work

[Rudie 0]

hi, still cant get this to work with all activex options enabled. it keeps asking for QuickTime to be installed.