MikeCermak 0 Posted May 31, 2016 One of my GeoVision machines is emailing me every 5 minutes to let me know "Disk storage space low detected." The system has 5 hard drives, and all of them have 5-10GB free. Is there a setting somewhere to adjust when this email goes out? Thanks! Share this post Link to post Share on other sites
Daryl733 0 Posted May 31, 2016 Check if the overwrite feature is turn on. 5-10GB is not a lot. Share this post Link to post Share on other sites
MikeCermak 0 Posted May 31, 2016 Thanks for the reply! Where is "overwrite feature"? System Log Setting - Keep Days: 12 (reduced from 15 earlier today, but hasn't helped) - Recycle: [checked] General Setting - Video Log Storage: Recycle: [checked] Share this post Link to post Share on other sites
jeromephone 6 Posted May 31, 2016 I have run into a problem where there are old files left on the harddrive if the number of days setting was put into effect after the files were saved. I would run a delete and go back a year or so and see what that frees up. Share this post Link to post Share on other sites
Daryl733 0 Posted June 1, 2016 System Log Setting - Keep Days: 12 (reduced from 15 earlier today, but hasn't helped) - Recycle: [checked] General Setting - Video Log Storage: Recycle: [checked] Recycle = Overwrite. You already enabled it. In that case you may want to check on the email alert. For some systems, when the current loop is completed before overwriting the current loop, it'll send out a warning saying that the disk is full. Also, avoid using the storage drive to store other files. Sometimes it screw up the DVR file systems. Just for disclaimer, I don't have much experience with Geovision system. I am speaking on general terms based on experiences with other brands. You may not want to take my advice into consideration if someone more expert comes along and reply to your post. Until then. Share this post Link to post Share on other sites
MikeCermak 0 Posted June 1, 2016 In that case you may want to check on the email alert. Yes, that's exactly what I'd like to do. I just don't know how. Share this post Link to post Share on other sites
Daryl733 0 Posted June 1, 2016 This might be of some assistance to you if no other people here are able to answer to your question. GeoVision Support Forum http://www.usavisionsys.com/forums/viewtopic.php?f=18&t=414 Share this post Link to post Share on other sites
ryan7 0 Posted June 2, 2016 Please enable Enlarge Recylce Threshold at General Setting --> Recycle Share this post Link to post Share on other sites
MikeCermak 0 Posted June 3, 2016 I think I have. (See post #3.) Share this post Link to post Share on other sites
