t310483317 0 Posted June 1, 2016 Hi can anyone help me with what wires should go where? I've hooked up 24v but still got these connections above to hook up but not sure where to start? DATA+ DATA- SCR VID(+) SCR (-) Is a document I found online but again still not understanding it unfortunately. Image of the unit itself. Any replies much appreciated! Share this post Link to post Share on other sites
Daryl733 0 Posted June 1, 2016 (edited) ....... Edited June 2, 2016 by Guest Share this post Link to post Share on other sites
t310483317 0 Posted June 1, 2016 Thank you so much for the reply! I'll give this a go soon and report back Cheers! Share this post Link to post Share on other sites
t310483317 0 Posted June 1, 2016 Cheers Daryl but no game, so put vid + to the centre wire of the bnc cable And I put scr to the outer mesh wire of bnc cable nothing so tried wiring scr to scr - to terminate it or something I read? and that didn't bring it up either Not sure what else to try but any suggestions from anyone welcome! Share this post Link to post Share on other sites
tomcctv 190 Posted June 1, 2016 Hi. Have you set up the address and rate on your dvr. Some domes will display the camera settings when you power down and back on again I know this dome as the vcl orbit. You have not supplied a pic of the tell entry board I need to see the settings Share this post Link to post Share on other sites
