Sumerian 0 Posted September 29, 2016 NVR DS-7716NI-SP / 16 w/ FW V3.4.21 build 160630 Cameras 2CD2732F-IS half of them are running firmware V5.1.2 build 140116 and the other half V5.2.5 build 141201 I could swear a few years ago when I installed the system there was an easy way to turn off the red light on the camera. I have searched and am unable to locate the option any longer. I am sure its right in front of me but I am not seeing it. Anyone familiar with this NVR or these cameras available to guide me to disabling the light? Share this post Link to post Share on other sites
Securame 0 Posted September 29, 2016 You mean the IR leds? Just change the day/night mode from "Auto" to "Day". That way the IR will always be off; keep in mind that without leds, you will NOT have night vision. Share this post Link to post Share on other sites
Sumerian 0 Posted September 29, 2016 I am thinking the small lights that are attached to the board not so much the IR lights that surround the camera lens area. Share this post Link to post Share on other sites
Securame 0 Posted September 29, 2016 There has never been a way to disable that led. I think that led can not even be seen when the camera is mounted, only when you have it without cover. Here is something that might work Share this post Link to post Share on other sites
Sumerian 0 Posted September 29, 2016 There has never been a way to disable that led. I think that led can not even be seen when the camera is mounted, only when you have it without cover.Here is something that might work LOL Share this post Link to post Share on other sites
minhvienthong 0 Posted October 14, 2016 There has never been a way to disable that led. I think that led can not even be seen when the camera is mounted, only when you have it without cover.Here is something that might work " title="Applause" /> nothing to say Share this post Link to post Share on other sites